Control Chief TM6000 Návod k obsluze stáhnout pdf (Strana 9)

TM 10-3930-660-10

WARNING

HYDRAULIC SYSTEM PRESSURE

Do NOT remove hydraulic tank filler cap or disconnect or remove any hydraulic system line or fitting unless

hydraulic system pressure has been relieved. Hydraulic system pressure can be over 2,500 psi (17,237 kPa),

even with engine and pump OFF. To relieve pressure, lower all hydraulic attachments to the ground and shut

down engine. Move control levers through all operating positions, then SLOWLY loosen hydraulic tank

filler cap. After maintenance, tighten all connections before applying pressure. Escaping hydraulic fluid

under pressure can penetrate the skin, causing serious injury or death.

WARNING

LOW BRAKE PRESSURE

Shut the vehicle down immediately whenever the low brake pressure warning light is illuminated. Failure to

do so may result in injury or death.

WARNING

MAINTENANCE PROCEDURES

Unless otherwise specified, perform all maintenance procedures with all equipment lowered to the ground,

transmission in Neutral, parking brake applied and the engine stopped. Failure to perform these tasks may

cause personal injury or death.

WARNING

NBC EXPOSURE

• If NBC exposure is suspected, personnel wearing protective equipment must handle all air cleaner media. Con-

sult your NBC Officer or NBC NCO for appropriate handling or disposal procedures.

• NBC contaminated filters must be handled using adequate precautions as described in FM 3-11.4, Multiservice

Tactics, Techniques, and Procedures for Nuclear, Biological, and Chemical (NBC) Protection, and must be dis-

posed of by trained personnel.

To order this NBC decal use:

National Stock Number (NSN) - 7690-01-114-3702

Part Number (PN) - 12296626

Commercial and Government Entity Code (CAGEC) - 19207

WARNING

IF NBC EXPOSURE IS SUSPECTED ALL AIR

FILTER MEDIA WILL BE HANDLED BY PER-

SONNEL WEARING FULL NBC PROTEC-

TIVE EQUIPMENT. SEE OPERATOR/

MAINTENANCE MANUAL.

7690-01-114-3702

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 200 201

Žádné komentáře

Control Chief TM6000 Návod k obsluze Strana 9